VISOR
®
Communications manual
2 Network connection
2.1 Integrating the VISOR
®
into the network / gateway
SensoFind/Active sensors will show a list with all the VISOR
®
vision sensors that are found on the
same network segment on the PC on which SensoFind is running. To update the list, press the
"Find" button for e.g. sensors that were only activated after viewing SensoFind.
For sensors which are installed in the network but are located in a different network segment via a
gateway, please enter the corresponding sensor IP address under "Add active sensor" and press
the button "Add". The corresponding sensor will now also appear in the "Active sensors" list, and
you will be able to access it and work with it.
06814859 - 1/24/2019-00 Page 7 EN
To Next Page
Loading...
