VISOR
®
Communications manual
11.1.3 Error codes
Error code Description
000 Successful
001 Error
003 Invalid parameter data
005 Invalid telegram
006 Input parameters with invalid size or invalid value
007 File does not exist
008 Recorder off
009 Matching image of requested type not found
010 Invalid file name or length
011 Invalid data length
012 Not allowed due to job set mismatch
013 Failed to start new job from job set
016 Firmware version mismatch
018 Calibration plate data not available
020 More than one vis file present
021 Sensor type does not match for vis file
030 Calibration not enabled
031 Calibration copy error
032 Mismatched input conditions for destination job
033 Calibration / validation error
034 Invalid number of points
035 Calibration error: Add point, e.g. last job result failed
036 Invalid fiducial
037 Job set protection error: "Permanent" job change is not allowed
038 Parameter values are not available to write / read
039 Sensor is in configuration mode. The telegram was rejected
040 Write / read error for parameter value
041 No matching job found
042 Format mismatch error
043 Jobset/Job saving error
06814859 - 1/24/2019-00 Page 88 EN
To Next Page
Loading...
