EasyManua.ls Logo

Sensopart Visor - Set Shutter Speed (BINARY)

Sensopart Visor
263 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VISOR
®
Communications manual
Set shutter speed (BINARY)
Telegrams: Availability and supported interfaces (Page 85)
Overview telegrams (Page 81)
Set shutter speed (binary) request string to sensor
Byte
no.
Data type Content Meaning
1 - 4
Unsigned
Int
0x09 Telegram length
5
Unsigned
Char
0x0E
0x0F
Set shutter speed temporarily
Set shutter speed permanently
Permanent change affect all parameters, including those that
were previously only changed temporarily.
6 - 9
Unsigned
Int
0xXX Shutter speed value
Set shutter speed (binary) response string from sensor
Byte
no.
Data type Content Meaning
1 - 4
Unsigned
Int
0x07 Telegram length
5
Unsigned
Char
0x0E
0x0F
Set shutter speed temporarily
Set shutter speed permanently
Permanent change affect all parameters, including those that
were previously only changed temporarily.
6 - 7
Unsigned
Short
0xXX Error codes (Page 88)
Additional information:
Accepted in run mode: Yes
Accepted in config mode: No
Accepted when Ready is low: Yes
Status of Ready signal during
processing:
Low
Page 203 EN 06814859 - 1/24/2019-00

Table of Contents

Related product manuals