Chapter 5 — Operating the Library Monitoring Your Library
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
169
The Drive Details screen shows the following information.
4. From the Drive Details screen click DLM to access the Drive Lifecycle
Management (DLM) report for the drive (see Viewing and Saving a
Detailed Drive Health Report on page 317).
5. Use the information on the Drive Details screen and the DLM report to
troubleshoot drive problems (see Troubleshooting Drives on page 412).
If the drive is in an error state, contact Spectra Logic Technical Support
(see
Contacting Spectra Logic on page 7).
This field... Shows...
Drive Health The drive health icon (see Using the Drive Health Icons on page 315).
Drive WWN The Fibre Channel WWN for the drive. See World Wide Names for Fibre
Channel Drives on page 66 for detailed information about the WWNs for drives.
The SAS port identifier for a SAS drive.
Note: This field is not present for SCSI drives.
Spectra Drive SN The location-based serial number for the drive while it is in the library. This
serial number makes it possible to replace one drive with another without
having to reconfigure the storage management software that accesses the drive.
Note: For TS11xx technology drives, the serial number provided in response
to SCSI commands from the host has 00 appended to the end of the number
that displays on the operator panel or is retrieved using XML.
Mfg Drive SN The serial number assigned to the physical drive by the drive manufacturer.
This serial number is required for tracking the drives when they are not inside
the library.
Drive FW The firmware version being used by the drive itself.
DCM FW The firmware version being used by the drive sled that houses the drive.
POST Status Shows the results of the drive’s POST (Power-On Self-Test).
Cleaning Status Shows the status of the drive’s Cleaning Tape Alert flag.
Library-based
Clean
Shows the last time that the drive was cleaned using the Auto Drive Clean feature.
Note: This field is only present when a cleaning partition is associated with
the storage partition containing the drive.
LED Status Shows the state of the drive’s front panel status LED (see Interpreting the Status
LED Information on page 416).
Display Character
(SCD) or Display
Message (MCD)
Shows the code displayed on the drive’s single-character display (SCD) or
multi-character display (MCD) (see Interpreting the SCD and MCD Codes on
page 416).
Cartridge Status Indicates whether the drive is configured to compress data as it is written and
whether the drive contains a cartridge.
Note: No tape motion indicates either that the drive is empty or, if the drive
contains a cartridge, that the tape is not moving.
To Next Page
Loading...
