Spectra T200 - Page 208

Chapter 6 — Configuring and Managing Partitions Confirming and Saving the Partition Settings
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
209
3. Click Next. The Save Partition screen displays.
Note: The Save Partition screen on your library may be different from
the ones shown in Figure 126 and Figure 125. The information
on this screen varies depending on the type of partition you
configured and the options you chose.
4. Review the information on the screen and confirm that all settings are
correct for this partition’s configuration.
 If the configuration information is correct, proceed to Step 5.
 If the configuration information is not correct, do one of the
following:
 Click Previous to move backward through the configuration
screens until you reach the settings that need correcting. As you
move backward through the configuration screens, the values
reset to their default values. After you reach the desired screen
and make the necessary changes, click Next to advance through
the screens and re-enter the necessary information until you
return to the Save Partition screen.
Note: If the screen requiring the correction is toward the
beginning of the configuration process, it may be easiest
to click Cancel and repeat the entire configuration
process.
 Click Cancel to configure the partition again from the beginning.
Figure 125 The Save Partition screen for a
cleaning partition.
Figure 126 The Save Partition screen for a
storage partition that uses a Global Spare and a
cleaning partition.