Chapter 8 — Using the Cartridge Inventory Moving Cartridges Within a Partition
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
256
5. Use the Destination drop-down list to select the type of location to
which you want to move the cartridge, then click Go. The destination
list refreshes to show all of the empty slots in the selected location.
Notes: The available destinations depend on the type of partition
you selected.
The To TAP option is only available when accessing the
BlueScale user interface from the front panel.
You cannot use the Inventory screen to move a cleaning cartridge in a cleaning
partition to a drive in a storage partition. Instead, use the Clean button on the
Drives screen (see Manually Cleaning a Drive on page 470).
Figure 151 Select the Destination for the cartridge.
Available destinations
(storage partition shown)
Partition Type Available Destinations
Storage
Storage—Lists all of the empty slots in the selected storage partition’s storage
pool.
Entry/Exit—Lists all of the empty slots in the selected partition’s entry/exit
pool.
To TAP—Configures a move that transfers the magazine containing the source
slot to the TAP so that you can remove the cartridge from the specified slot.
The magazine is then returned to its original location.
Drives—Lists the drives in the partition that are currently empty.
All—Lists all of the empty slots in the partition, regardless of the location.
Note: Selecting a specific destination type instead of using All displays fewer
items through which you must scroll to locate the desired destination slot.
To Next Page
Loading...
