Chapter 8 — Using the Cartridge Inventory Moving Cartridges Within a Partition
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
258
Process the Move Queue Use the following steps to process the move
queue created using the Inventory screen.
1. If you are moving cartridges into the library, prepare the cartridges as
described in Preparing Cartridges for Use on page 218.
Note: When importing cartridges, you do not need to put the prepared
cartridges into a magazine. You are prompted to insert the
prepared cartridge into the selected empty slot in the magazine
that is delivered to the TAP.
2. Choose one of the move processing modes:
Figure 153 Click Start Moves or Start in Background to begin processing the
move queue.
Click Start Moves
or Start in
Background.
Click... To...
Start Moves Begin processing the moves in the order that they are listed in the queue. A
progress screen tracks the progress of the move operations. When all of the
moves in the queue have been processed, the screen displays the status of each
move. No other operations can be started until the moves complete.
Note: If the TAP is the source for or destination for a move, a Feedback
Required screen displays.
From TAP — The magazine containing the destination slot is moved to the TAP
so that you can insert a cartridge in the slot indicated by the Feedback
Required screen. The magazine is then returned to its original location.
To TAP — The magazine containing the source slot is moved to the TAP so that
you can remove or replace the cartridge from the slot indicated by the
Feedback Required screen. The magazine is then returned to its original
location.
To Next Page
Loading...
