Chapter 12 — Library Troubleshooting Capturing Traces
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
356
Procedure Use the following steps to capture the desired trace.
1. Log into the library as a user with superuser or administrator
privileges.
2. From the toolbar menu, select Maintenance > Tools to display the
Maintenance Tools screen.
3. If you want to save the traces to a USB device, connect the USB device
to the LCM and allow time for the device to mount.
4. Select Traces. The System Traces screen displays with the trace options
that were selected the last time the screen was viewed.
5. Select the type of trace that Spectra Logic Technical Support requested.
LCM Trace—Captures a trace relating to a single aspect of operations
related to the LCM.
Component Trace—Captures a trace relating to the logical library or
a single aspect of operations related to the robotics or a controller
(RIM or F-QIP).
Note: The RIMs in the library are listed as F-QIPs.
Figure 210 Select the traces you want to capture on the
System Traces screen (Error Log trace results shown).
To Next Page
Loading...
