Chapter 15 — Maintaining the Drives Updating Drive Firmware
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
488
2. Select or clear each drive’s check box to indicate whether or not to
update the drive.
Note: If a drive is not empty, it is still included in this list; however, its
check box is disabled, with a note indicating that a tape is loaded
in the drive.
3. Click Next. The drive firmware update process begins updating the
selected drives in parallel. A progress screen displays until the process
completes, in approximately 15 to 30 minutes.
4. After the drive firmware update completes, the Staged Firmware
Update Result screen displays the results of the update process.
Click OK to return to the Drives screen.
5. After the update is complete, use your storage management software to
restart any backup processes.
Figure 303 Select the drives to update.
The Drives screen displays... when...
The library starts the firmware update process.
The staging status line changes to “Committing”.
The drive firmware update process is complete.
The staging drive icon changes back to the drive icon,
and the staging status line disappears.
Figure 304 Click OK to return to the Drives screen.
To Next Page
Loading...
