©Tormach® 2023
Specifications subject to change without notice.
Page 7 Tormach 1100M® Operator's Manual (Version 1223A)
For the most recent version, see tormach.com/support
TABLE OF CONTENTS
Installation 57
Prepare the Machine 58
Disassemble the Original Drawbar 58
Assemble the Power Drawbar 59
Install the FRL 61
Set Up the FRL 62
Make Air Connections 62
Adjust the Power Drawbar 64
Adjust the Drawbar Tension 64
About Drawbar Tension 64
Adjust the Initial Setup 65
4.8.3 Install the Flood Coolant Kit 66
Adjust the Coolant Pump Motor Strapping 66
Set Up the Flood Coolant Kit 66
4.8.4 Install the Automatic Tool Changer (ATC) 67
Required Tools 68
Required Tools for Installation 68
Required Tools for Verification 68
Air Requirements 68
Before You Begin 68
Disassemble the Power Drawbar Button 68
Install the Air Cylinder 69
Mount the Automatic Tool Changer (ATC) Bracket 69
Install the Main Assembly 70
Level the Automatic Tool Changer (ATC) 70
Prepare the Machine 70
Examine Perpendicularity in the Y Direction 71
Examine Perpendicularity in the X Direction 71
Examine the Alignment of the Carousel Door Opening 71
Make Air Connections 73
Make Electrical Connections 73
Verify the Installation 73
Adjust the Power Drawbar 74
Adjust the Drawbar Tension 74
About Drawbar Tension 75
Adjust the Initial Setup 75
Adjust the Tool Tray Load Position 76
Verify the Alignment 77
Set the Tool Change Height 77
Adjust for Rotational Play 77
4.8.5 Install the 4th Axis 78
Install the M/MX A-Axis Driver (PN38954) 78
Set the Driver DIP Switches 78
Install the A-Axis Motor Driver 79
Set Up the 6 in. or 8 in. Rotary Table 79
To Next Page
Loading...
