EasyManua.ls Logo

Toro Groundsmaster 5910 Series - Page 155

Toro Groundsmaster 5910 Series
559 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ProcedureforCuttingDeckCircuitReliefPressureTest(continued)
IMPORTANT
Makesurethattheoilowindicatorarrowontheowgaugeis
showingthattheoilwillowfromthemanifold,throughthetester
andintothedisconnectedhydraulichose.
4.Install40GPMtester(owandpressure)inseriesbetweenthedeckmanifold
portM1andthedisconnectedhose.Makesuretheowcontrolvalveon
testerisfullyopen.
CAUTION
Cuttingdeckbladeswillrotatewhencuttingdecksareloweredwith
PTOswitchinONposition.Keepawayfromcuttingdecksduring
testtopreventpersonalinjuryfromrotatingblades.Donotstand
infrontofthemachine.
5.Afterinstallinghydraulictester,startengineandrunatlowidlespeed.Check
forhydraulicleakageattesterconnectionsandcorrectbeforeproceeding
withtest.
6.Increaseenginespeedtohighidlespeed(2530RPM).Releasetheparking
brakeandengagethecuttingdecks.
7.Watchtesterpressuregaugecarefullywhileslowlyclosingthetesterow
controlvalvetofullyclosed.
8.Asthecuttingdeckcircuitreliefvalvelifts,systempressureshouldbe
approximately:
203to224bar(2950to3250PSI)forthecenterandleftdecks.
127to148bar(1850to2150PSI)fortherightdeck.
9.Afteridentifyingreliefvalvepressure,fullyopentesterowcontrolvalve,
disengagecuttingdecksanddecreaseenginespeedtolowidle.Shutoff
engineandrecordtestresults.
10.Ifreliefpressureisincorrect,removePRVvalveondeckmanifoldandclean
orreplacevalve(seeTractionControlManifoldService(page5–112)).After
PRVvalveservice,performreliefpressuretestagainandifpressureis
stilllow,checkforrestrictioningearpumpinletline.Therstgearpump
section(forfrontdeckcircuit)and/orthesecondgearpumpsection(forside
deckcircuits)couldalsobesuspectedofwear,damageorinefciency(see
ProcedureforGearPumpFlowTest(page5–68)).
11.Whenreliefpressuretestingiscomplete,disconnecttesterfromdeck
manifoldttingandhydraulichose.Reconnecthydraulichosethatwas
disconnectedfortestprocedure.
12.Repeattestforothercuttingdeckcircuitsifnecessary.
13.Whentestingiscomplete,makesurethatthehydraulictankisfullbefore
returningmachinetooperation.
Groundsmaster
®
5900&5910
Page5–55
HydraulicSystem:Testing
16227SLRevB

Table of Contents

Other manuals for Toro Groundsmaster 5910 Series

Related product manuals