Toro Groundsmaster 5910 Series - Page 472

SeeDriveBeltIdlerAssemblies(page8–11),BladeSpindles(page8–14),
CastorForksandWheels(page8–21)andDeckSkidsandFrontDeckRoller
(Figure339andFigure340)(page8–23)forremoval,installationandservice
information.
WingCuttingDeckRemoval(Figure327)
1.Positionmachineonaclean,levelsurface.Lowercuttingdecks,stopengine
andremovekeyfromthekeyswitch.
2.Removecuttingdeckoutercovertoaccesshydraulicdeckmotor.
3.Removethree(3)hoseguidesfromcuttingdeck.Leavetwo(2)loopguides
(item6and7)onhydraulichoses.
4.Removehydraulicmotorfromcuttingdeck(seeCuttingDeckMotor(page
5–118)).Positionandsupportmotorawayfromcuttingdeck.DONOTallow
cuttingdeckmotortohangfromhydraulichoses.
5.Removeeight(8)angeheadscrews(item11)andlocknutsthatsecure
deckconnection(item10)tocuttingdeck.
6.Startengineandraiseliftarmslightly.Stopengineandremovekeyfromthe
keyswitch.
7.Slidethecuttingdeckawayfromthetractionunit.
WingCuttingDeckInstallation(Figure327)
1.Positionmachineonaclean,levelsurface.Lowerwingdeckliftarm,stop
engineandremovekeyfromthekeyswitch.
2.Positionthewingcuttingdecktoapartiallyraisedliftarm.
3.Startengineandlowerliftarmwhilealigningdeckconnectiontocuttingdeck.
Stopengineandremovekeyfromthekeyswitch.
4.Installdeckconnectiontocuttingdeckwitheight(8)angeheadscrews(item
11)andlocknutsandtightenfasteners.
5.Installhydraulicmotortocuttingdeck(seeCuttingDeckMotor(page5–118)).
6.Positionandsecurethree(3)hoseguidestocuttingdeck.
7.Installallremovedcuttingdeckcovers.
8.Lubricategreasettingsoncuttingdeckandliftarmassemblies(see
machineOperator’sManual).
CuttingDecks:ServiceandRepairs
Page8–10
Groundsmaster
®
5900&5910
16227SLRevB