CHAPTER 19: Setting Up a High Availability System
434 Vcontroller
4 If you plan to set up more than one primary/Standby
system in this subnet, delete the 3 in the HA Group ID
field and type a number that uniquely identifies this
system within the network context. (The number can
range between 3 and 255.)
HA Group IDs are used to identify High Availability Active/
standby pairs on your network. Each HA Active/Standby pair
should have a separate Group ID. You need to change this number
only if other devices are running the VRRP protocol (using the
same VRRP ID) on the networks connected to this appliance.
VRRP allows both HA security appliances to share the same
MAC and IP addresses.
5 Click OK to save the parameter entries and close the
Advanced HA Parameters dialog box.
6 When the High Availability tab reappears, click HA
Sync to synchronize your appliances.
7 Click Apply to apply the settings, or Reset to reset the
settings.
8 Click Close.
To Next Page
Loading...
