3.6 Running an Interrupt Scan
134
3.6 Running an Interrupt Scan
This section describes how to interrupt an ongoing continual print job to run an urgent scan job.
The Multi Send Scan feature is not available during the interrupt mode.
The Interrupt Scan function is not available during copying.
1.
Press the <Interrupt> button on the control panel.
The <Interrupt> button lights up, indicating the Interrupt mode is enabled.
2.
During a print job, the [Services Home] screen appears.
Press [Store to Folder] or [Scan to PC].
3.
Set other features as necessary.
4.
Load the document.
5.
After you finish the interrupt scanning, press the
[Interrupt] button.
The <Interrupt> button goes out, indicating the Interrupt
mode is exited.
The suspended print job resumes.
To Next Page
Loading...
