305
9.4 Copy Service Settings
9.4.5 Variable Length Settings
You can use this feature to set the default variable length to be used when [Variable Length] is specified on the
[Paper Cut Mode] screen under the Copy feature.
The default variable length can be set for individual paper sizes, in the range of 210 to 5,000 mm.
The factory defaults are:
Series Item Factory Default
A series A0 Wide 1189mm
A1 Wide 841mm
A2 Wide 594mm
A3 Wide 420mm
JIS B series B1 Wide 1030mm
B2 Wide 728mm
B3 Wide 515mm
ISO B Series B1 Wide 1000mm
B2 Wide 707mm
B3 Wide 500mm
Special A series 880mm Wide 1240mm
620mm Wide 880mm
440mm Wide 620mm
310mm Wide 440mm
Arch series 36" Wide 1219mm
30" Wide 1066mm
24" Wide 914mm
18" Wide 610mm
15" Wide 533mm
12" Wide 457mm
ANSI Series 34" Wide 1118mm
22" Wide 864mm
17" Wide 559mm
11" Wide 432mm
To Next Page
Loading...
Need help?
General