4.3 Calling up a Stored Program
168
4.3 Calling up a Stored Program
The following describes how to select a registered stored program.
1.
Press the <Services Home> button on the control panel.
2.
On the menu screen, press [Stored Copy Program] or [Stored Scan Program].
3.
Select the number of the stored program containing the
settings you want to call up.
Only the numbers that are registered can be
selected.
Press [ ] to display the previous screen, and
press [ ] to display the next screen.
If you want to display a specific stored program
number at the top, enter that number in [Go
to].
4.
After the stored program is called up from memory, set
other features as necessary.
When the stored program has been called up, the number of the stored program is displayed for seven
seconds on the message area.
5.
Load your documents and run the copy or scan job.
To Next Page
Loading...
Need help?
General