Xerox Wide Format 6705 System

8
Problem Solving
8.12 Finding More
278
8.12.6 To Change the Default Output File Format of Scanned Data
The following describes how to change the default output file format of scanned data.
Steps
St
1.
Press the <Log In/Out> button on the control panel.
2.
Enter the user ID of the system administrator, by using the numeric keypad or the keyboard displayed on the
screen, and press [Enter].
Note

By factory default, the User ID is "11111".
3.
On the menu screen, press [Tools].
4.
Press [System Settings] > [Scan Service Settings] > [Scan Defaults].
5.
Select a file format under [File Format], and press the
<Start> button.