1
Before Using the Machine
1.11 Cleaning the Machine
62
1.11 Cleaning the Machine
This section describes how to clean the machine.
If the reflector on the back of the document cover or the surface of the scanning glass is dirty, it may result in black
lines or streaks on the entire copies.
Do not use benzene, paint thinner, or other volatile liquids or spray insect repellent on the machine as doing so
may discolor, deform, or crack covers.
If it is difficult to remove dirt, try gently wiping with a firmly wrung soft cloth moistened with a small amount of
neutral detergent. Then, wipe with a dried cloth.
Do not use cleaning agents other than water or neutral detergent.
Cleaning the machine with an excessive amount of water may cause the machine to malfunction or damage
originals during copying.
1.
Turn off the power switch ( ) and the power breaker of the
machine ( ).
Turn off the power switch and the power breaker when
cleaning to avoid the risk of electric shock.
2.
Pull the document cover toward you until it stops, and lift it up to
remove it.
When cleaning this product, use the designated cleaning materials exclusive to it. Other cleaning materials may
result in poor performance of the product. Never use aerosol cleaners, or it may catch fire and cause explosion.
When cleaning this product, always switch off the power, and unplug the product. Access to a live machine
interior may cause electric shock.
To Next Page
Loading...
Need help?
General