July, 2007
4-34
WorkCentre 5020
REP 5.1.3
Initial Issue
Repairs and Adjustments
5. Remove the Fuser Lamp Housing (Figure 4).
1 Remove 2 Screws.
2 Carefully remove the Fuser Lamp Housing.
Figure 4 Removing the Fuser Lamp Housing
6. Remove the Fuser Lamp by pulling it through the Fuser Roll (Figure 5).
NOTE: Do not lose the Fuser Lamp Mount.
Figure 5 Removing the Fuser Lamp
Replacement
CAUTION
Do not touch the glass part of the Fuser Lamp unless you are are wearing gloves.
1. To install, do the removal steps in reverse order.
Screws
Fuser Lamp Housing
Fuser Lamp
Fuser Roll
Fuser Lamp Mount
To Next Page
Loading...
