July, 2007
4-37
WorkCentre 5020
REP 5.1.4
Repairs and Adjustments
Initial Issue
Replacement
CAUTION
Do not touch the glass part of the Fuser Lamp unless you are wearing gloves.
1. To install, do the removal steps in reverse order.
NOTE: When installing the Drive Gear, make sure that the Locating Key is oriented as
shown in Figure 6.
Figure 6 Installing the Drive Gear
CAUTION
Make sure the stripper fingers are oriented correctly when reinstalling the Stripper Finger
Assembly, as shown in Figure 7.
Figure 7 Setting the Stripper Fingers
Locating Key
To Next Page
Loading...
