July, 2007
2-6
WorkCentre 5020
Initial Issue
Status Indicator RAPS
Error Code List
NOTE: In the “Record in Error Log” column, “O” = yes and “X” = no.
Error
Code
Error Name/Explanation/I/O Diagnostic Codes/Check Items
Record in
Error Log
RAP BSD
C1-1
Error Name
Tray1 F/O#1 SNR on JAM
Explanation
Timeout between Tray1 Feed Clutch ON and Tray1 Feed Sensor ON.
I/O Diagnostic Codes (How to Enter the Diagnostic Mode)
• [08-07] Tray1 Feed Sensor
• [08-12] Tray1 Feed Clutch
Check Items
• Feed Roll or Retard Pad dirty, contaminated with paper dust, worn, or faulty
• Tray1 Feed Sensor dirty and Sensor Actuator deformed or damaged
• Paper damaged, not within specification, or not loaded correctly
• Foreign matter, burrs, or paper in the paper path
• Drive gear worn or damaged
• Tray1 Feed Clutch faulty
• Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the Tray 1 Feed Sensor
(PL 2.5)(REP 2.5.1).
– Wire between Tray 1 Feed Sensor J158-3 ( P/J158) and LVPS J501-6 ( P/J501)
– Wire between Tray 1 Feed Sensor J158-2 and LVPS J501-7
– Wire between Tray 1 Feed Sensor J158-1 and LVPS J501-8
• Replace the Tray1 Feed Clutch (PL 2.2) (REP 2.2.1) and the AIOC PWB (PL 8.1) (REP 8.1.1) in that order.
O -
CH8.1
Figure 1
To Next Page
Loading...
