YASKAWA JEPMC-MP2300-Y Series

iv
■
Graphic Symbols Used in this Manual
The graphic symbols used in this manual indicate the following type of information.
■
Indication of Reverse Signals
In this manual, the names of reverse signals (ones that are valid when low) are written with a
forward slash (/) before the signal name, as shown in the following example:
Notation Examples
 Related Manuals
The following table lists the manuals relating to the MP2500(M). Refer to these manuals as
required.

This symbol is used to indicate important information that should be memorized or minor precautions,
such as precautions that will result in alarms if not heeded.
• S-ON =Å@/S-ON
• P-CON =Å@/P-
CON
Manual Name Manual Number Contents
Machine Controller MP2300 Communication
Module
User’s Manual
SIEP C880700 04 Describes the functions, specifications, and appli-
cation methods of the MP2300 Communication
Modules (217IF, 218IF, 260IF, 261IF).
Machine Controller MP900/MP2000 Series
User’s Manual, Ladder Programming
SIEZ-C887-1.2
Describes the instructions used in MP900/
MP2000 ladder programming.
Machine Controller MP900/MP2000 Series
User’s Manual
Motion Programming
SIEZ-C887-1.3
Describes the instructions used in MP900/
MP2000 motion programming.
Machine Controller MP900/MP2000 Series
MPE720 Software for Programming Device
User’s Manual
SIEP C880700 05
Describes how to install and operate the MP900/
MP2000 Series programming system (MPE720).
Σ Series SGM/SGD
User’s Manual
SIEZ-S800-26.3 Describes the Σ Series SERVOPACK models,
specifications, and capacity selection methods.
Σ Series SGM/SGD
User’s Manual
High-speed Field Network
MECHATROLINK-compatible AC Servo Drivers
SIEZ-S800-26.4 Describes the Σ Series SERVOPACK models,
specifications, and capacity selection methods.
Σ-II Series
SGMH/SGDM User’s Manual
SIEP S8000 05
Describes the installation, wiring, trial operation,
function applications methods, maintenance, and
inspection of the Σ-II Series SERVOPACKs.
Σ-II Series
SGMH/SGDM User’s Manual
SIEP S8000 15
Describes the installation, wiring, trial operation,
function applications methods, maintenance, and
inspection of the Σ-II Series SERVOPACKs.
Σ-III Series SGMH/SGDS
User’s Manual
SIEP S800000 00
Describes the models, specifications, wiring, trial
operation, adjustment, function application meth-
ods, maintenance, and inspection of the Σ-III
Series SERVOPACKs and Servomotors.
Σ-III Series SGMS/SGDS Digital Operator
Operating Instructions
TOBEP S800000
01
Describes the operating methods of the JUSP-
OP05A Digital Operator.