Appendix B 419
Key Definitions
Softkeys displayed by pressing the [Copy] key
B. Key Definitions
Table B-102 Copy data (Copy Contents) menu
Key operation: [Copy] - SELECT CONTENTS - LIST VALUE
[Copy] - SELECT CONTENTS - OPERATING PARAMETERS
[Copy] - SELECT CONTENTS - CAL KIT VALUE
[Copy] - SELECT CONTENTS - COMPEN KIT VALUE
Softkey Function GPIB command
START Prints the information (measured value list, operating parameter, or calibration
kit value) displayed on the screen with the printer connected to the printer
parallel port on the rear panel. Note that the information is not displayed on the
screen if you have not selected the ALL INSTUMENT key or the HALF INSTR
HALF BASIC key in Table B-21, “Display allocation (Disp Alloc) menu,” on
page 369.
PRINALL
ABORT Aborts the printing operation. COPA
TIME on OFF Toggles on and off the time stamp function used when outputting to a printer. If
this is set to on, the current time and date are printed first, and then the specified
screen information is printed. This configuration is common to the TIME on
OFF key in Table B-100, “Copy configuration (Copy Setup) menu (2/2),” on
page 418.
COPT {ON|OFF}
NEXT PAGE Displays the next page of the list displayed on the screen. NEXP
PREV PAGE Displays the previous page of the list displayed on the screen. PREP
RESTORE DISPLAY ä Displays Table B-101, “Copy data selection (Copy Contents) menu,” on page
418.
RESD
Table B-103 List sweep segment copy start (Copy Contents) menu
Key operation: [Copy] - SELECT CONTENTS - LIST SWEEP SEGMENTS
Softkey Function GPIB command
START Prints the list sweep table displayed on the screen with the printer connected to
the printer parallel port on the rear panel. Note that the information is not
displayed on the screen if you have not selected the ALL INSTUMENT key or
the HALF INSTR HALF BASIC key in Table B-21, “Display allocation (Disp
Alloc) menu,” on page 369.
PRINALL
ABORT Aborts the printing operation. COPA
TIME on OFF Toggles on and off the time stamp function used when outputting to a printer. If
this is set to on, the current time and date are printed first, and then the specified
screen information is printed. This configuration is common to the TIME on
OFF key in Table B-100, “Copy configuration (Copy Setup) menu (2/2),” on
page 418.
COPT {ON|OFF}
DISP MODE [ ] Selects start value and stop value [STRT-STP] or center value and span value
[CTR-SPAN] as the display format of the sweep range of the printed list sweep
table.
DISMPRM
{STSP|CTSP}
NEXT PAGE Displays the next page of the list displayed on the screen. NEXP
PREV PAGE Displays the previous page of the list displayed on the screen. PREP
RESTORE DISPLAY ä Displays Table B-101, “Copy data selection (Copy Contents) menu,” on page
418.
RESD
To Next Page
Loading...
Need help?
General
