AudioCodes Mediant 500L MSBR

User's Manual 1002 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
[UseReferredByForCalling
Number]
Determines whether the device uses the number from the URI in the
SIP Referred-By header as the calling number in the outgoing Q.931
Setup message, when SIP REFER messages are received.
 [0] = (Default) No
 [1] = Yes
Notes:
 This parameter is applicable to all ISDN (TBCT, RLT, ECT) and CAS
blind call transfers (except for in-band) and when the device receives
SIP REFER messages with a Referred-By header.
 This manipulation is done before regular IP-to-Tel source number
manipulation.
[SwapTel2IPCalled&Calli
ngNumbers]
Determines whether the device swaps the calling and called numbers
received from the Tel side (for Tel-to-IP calls). The SIP INVITE
message contains the swapped numbers.
 [0] = (Default) Disabled
 [1] = Swap calling and called numbers
Note: This parameter can also be configured for a Tel Profile (in the Tel
Profile table).
Web/EMS: Add Prefix to
Redirect Number
CLI: add-pref-to-redir-nb
[Prefix2RedirectNumber]
Defines a string prefix that is added to the Redirect number received
from the Tel side. This prefix is added to the Redirect Number in the SIP
Diversion header.
The valid range is an 8-character string. By default, no value is defined.
Web: Add Number Plan
and Type to RPI Header
EMS: Add Ton 2 RPI
CLI: np-n-type-to-rpi-hdr
[AddTON2RPI]
Determines whether the TON/PLAN parameters are included in the
Remote-Party-ID (RPID) header.
 [0] No
 [1] Yes (default)
If the Remote-Party-ID header is enabled (EnableRPIHeader = 1) and
AddTON2RPI = 1, it's possible to configure the calling and called
number type and number plan using the Number Manipulation tables for
Tel-to-IP calls.
Web/EMS: Source
Manipulation Mode
CLI: src-manipulation
[SourceManipulationMod
e]
Determines the SIP headers containing the source number after
manipulation:
 [0] = (Default) The SIP From and P-Asserted-Identity headers
contain the source number after manipulation.
 [1] = Only SIP From header contains the source number after
manipulation, while the P-Asserted-Identity header contains the
source number before manipulation.
Calling Name Manipulations IP-to-Tel Table
CLI: configure voip > gw
manipulations calling-
name-map-ip2tel
[CallingNameMapIp2Tel]
Configures rules for manipulating the calling name (caller ID) in the
received SIP message for IP-to-Tel calls. This can include modifying or
removing the calling name. The format of this table ini file parameter is
as follows:
[ CallingNameMapIp2Tel ]
FORMAT CallingNameMapIp2Tel_Index =
CallingNameMapIp2Tel_ManipulationName,
CallingNameMapIp2Tel_DestinationPrefix,
CallingNameMapIp2Tel_SourcePrefix,
CallingNameMapIp2Tel_CallingNamePrefix,
CallingNameMapIp2Tel_SourceAddress,
CallingNameMapIp2Tel_RemoveFromLeft,