User's Manual 1030 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
user authentication and authorization.
You can use the dollar ($) sign to represent the username.
For example, if this parameter is set to
"(sAMAccountName=$)" and the user logs in with the
username "SueM", the LDAP query is run for
sAMAccountName=SueM.
Web: Use LDAP for Web/Telnet Login
CLI: configure voip > ldap > enable-
mgmt-login
[MgmtLDAPLogin]
Enables LDAP-based management-user login
authentication and authorization.
[0] Disable (default)
[1] Enable
Note: For this parameter to take effect, a device reset is
required.
[LDAPDebugMode]
Determines whether to enable the LDAP task debug
messages. This is used for providing debug information
regarding LDAP tasks.
The valid value range is 0 to 3. The default is 0.
Web: MS LDAP OCS Number attribute
name
EMS: LDAP ocs Number Attribute Name
CLI: ldap-ocs-nm-attr
[MSLDAPOCSNumAttributeName]
Defines the name of the attribute that represents the user's
Lync number in the Microsoft AD database.
The valid value is a string of up to 49 characters. The
default is "msRTCSIP-Line".
Web: MS LDAP PBX Number attribute
name
CLI: ldap-pbx-nm-attr
[MSLDAPPBXNumAttributeName]
Defines the name of the attribute that represents the user
PBX number in the Microsoft AD database.
The valid value is a string of up to 49 characters. The
default is "telephoneNumber".
Web: MS LDAP MOBILE Number
attribute name
CLI: ldap-mobile-nm-attr
[MSLDAPMobileNumAttributeName]
Defines the name of the attribute that represents the user
Mobile number in the Microsoft AD database.
The valid value is a string of up to 49 characters. The
default is "mobile".
CLI: ldap-private-nm-attr
[MSLDAPPrivateNumAttributeName]
Defines the name of the attribute that represents the user's
private number in the AD. If this value equals the value of
the MSLDAPPrimaryKey or MSLDAPSecondaryKey
parameter, then the device queries the AD for the
destination number in this private attribute name;
otherwise, this parameter is not used as a search key.
The default is "msRTCSIP-PrivateLine".
Web: MS LDAP DISPLAY Name
Attribute Name
CLI: ldap-display-nm-attr
[MSLDAPDisplayNameAttributeName]
Defines the attribute name that represents the Calling
Name in the AD for LDAP queries based on calling
number.
The valid value is a string of up to 49 characters. The
default is "displayName".
CLI: ldap-primary-key
[MSLDAPPrimaryKey]
Defines the name of the attribute used as a query search
key for the destination number in the AD. This is used
instead of the "PBX" attribute name (configured by the
MSLDAPPBXNumAttributeName parameter).
The default is not configured.
CLI: ldap-secondary-key
[MSLDAPSecondaryKey]
Defines the name of the attribute used as the second
query search key for the destination number in the AD, if
the primary search key or PBX search is not found.
To Next Page
Loading...
