User's Manual 208 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
Web: Time Offset
CLI: time-offset
[DhcpServer_TimeOffset]
Defines the Greenwich Mean Time (GMT) offset (in seconds)
that the DHCP server assigns to the DHCP client. The value
is sent in DHCP Option 2 (Time Offset).
The valid range is -43200 to 43200. The default is 0.
Web: TFTP Server
CLI: tftp-server-name
[DhcpServer_TftpServer]
Defines the IP address or name of the TFTP server that the
DHCP server assigns to the DHCP client. The TFTP server
typically stores the boot file image, defined in the 'Boot file
name' parameter (see below). The value is sent in DHCP
Option 66 (TFTP Server Name).
The valid value is a string of up to 80 characters. By default,
no value is defined.
Web: Boot file name
CLI: boot-file-name
[DhcpServer_BootFileName]
Defines the name of the boot file image for the DHCP client.
The boot file stores the boot image for the client. The boot
image is typically the operating system the client uses to load
(downloaded from a boot server). The value is sent in DHCP
Option 67 (Bootfile Name). To define the server storing the
file, use the 'TFTP Server' parameter (see above).
The valid value is a string of up to 256 characters. By default,
no value is defined.
The name can also include the following case-sensitive
placeholder strings that are replaced with actual values if the
'Expand Boot-file Name' parameter is set to Yes:
<MAC>: Replaced by the MAC address of the client (e.g.,
boot_<MAC>.ini). The MAC address is obtained in the
client's DHCP request.
<IP>: Replaced by the IP address assigned by the DHCP
server to the client.
Web: Expand Boot-file Name
CLI: expand-boot-file-name
[DhcpServer_ExpandBootfileName]
Enables the use of the placeholders in the boot file name,
defined in the 'Boot file name' parameter.
[0] No
Yes (default)
Web: Override Router
CLI: override-router-address
[DhcpServer_OverrideRouter]
Defines the IP address (IPv4 in dotted-decimal notation) of
the default router that the DHCP server assigns the DHCP
client. The value is sent in DHCP Option 3 (Router).
The default value is 0.0.0.0. If not specified (empty or
“0.0.0.0”), the IP address of the default gateway configured in
the Interface table for the IP network interface that you
associated with the DHCP server (see the 'Interface Name'
parameter above) is used.
Web: SIP Server
CLI:sip-server
[DhcpServer_SipServer]
Defines the IP address or DNS name of the SIP server that
the DHCP server assigns the DHCP client. The client uses
this SIP server for its outbound SIP requests. The value is
sent in DHCP Option 120 (SIP Server). After defining this
parameter, use the 'SIP server type' parameter (see below)
to define the type of address (FQDN or IP address).
The valid value is a string of up to 256 characters. The
default is 0.0.0.0.
To Next Page
Loading...
