AudioCodes Mediant 500L MSBR

User's Manual 18. Services
Version 6.8 207 Mediant 500L MSBR
Parameter Description
Web: End IP Address
[DhcpServer_EndIPAddress]
Defines the ending IP address (IPv4 address in dotted-
decimal format) of the IP address pool range used by the
DHCP server to allocate addresses.
The default value is 192.168.0.149.
Note: The IP address must belong to the same subnet as the
associated interface’s IP address and must be "greater or
equal" to the starting IP address defined in 'Start IP Address'.
Web: Subnet Mask
CLI: subnet-mask
[DhcpServer_SubnetMask]
Defines the subnet mask (for IPv4 addresses) for the DHCP
client. The value is sent in DHCP Option 1 (Subnet Mask).
The default value is 0.0.0.0.
Note: The value must be "narrower" or equal to the subnet
mask of the associated interface’s IP address. If set to
"0.0.0.0", the subnet mask of the associated interface is
used.
Web: Lease Time
CLI: lease-time
[DhcpServer_LeaseTime]
Defines the duration (in minutes) of the lease time to a DHCP
client for using an assigned IP address. The client needs to
request a new address before this time expires. The value is
sent in DHCP Option 51 (IP Address Lease Time).
The valid value range is 0 to 214,7483,647. The default is
1440. When set to 0, the lease time is infinite.
Web: DNS Server 1
CLI: dns-server-1
[DhcpServer_DNSServer1]
Defines the IP address (IPv4) of the primary DNS server that
the DHCP server assigns to the DHCP client. The value is
sent in DHCP Option 6 (Domain Name Server).
The default value is 0.0.0.0.
Web: DNS Server 2
CLI: dns-server-2
[DhcpServer_DNSServer2]
Defines the IP address (IPv4) of the secondary DNS server
that the DHCP server assigns to the DHCP client. The value
is sent in DHCP Option 6 (Domain Name Server).
Web: NetBIOS Name Server
CLI: netbios-server
[DhcpServer_NetbiosNameServer]
Defines the IP address (IPv4) of the NetBIOS WINS server
that is available to a Microsoft DHCP client. The value is sent
in DHCP Option 44 (NetBIOS Name Server).
The default value is 0.0.0.0.
Web: NetBIOS Node Type
CLI: netbios-node-type
[DhcpServer_NetbiosNodeType]
Defines the node type of the NetBIOS WINS server for a
Microsoft DHCP client. The value is sent in DHCP Option 46
(NetBIOS Node Type).
 [0] Broadcast (default)
 [1] peer-to-peer
 [4] Mixed
 [8] Hybrid
Web: NTP Server 1
CLI: ntp-server-1
[DhcpServer_NTPServer1]
Defines the IP address (IPv4) of the primary NTP server that
the DHCP server assigns to the DHCP client. The value is
sent in DHCP Option 42 (Network Time Protocol Server).
The default value is 0.0.0.0.
Web: NTP Server 2
CLI: ntp-server-2
[DhcpServer_NTPServer2]
Defines the IP address (IPv4) of the secondary NTP server
that the DHCP server assigns to the DHCP client. The value
is sent in DHCP Option 42 (Network Time Protocol Server).
The default value is 0.0.0.0.