User's Manual 390 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
[_CallingNamePrefix]
You can use special notations for denoting the prefix. For example, to
denote calls without a calling name, use the $ sign. For a description of
available notations, see ''Dialing Plan Notation for Routing and
Manipulation Tables'' on page
777.
The default value is the asterisk (*) symbol (i.e., any calling name
prefix).
Web: Source Trunk Group
ID
CLI: src-trunk-group-id
[_SrcTrunkGroupID]
Defines the source Trunk Group ID from where the Tel-to-IP call was
received.
The default value is -1, which denotes any Trunk Group.
Note: This parameter is applicable only to the Calling Name
Manipulation Table for Tel-to-IP Calls table.
Web/EMS: Source IP
Address
CLI: src-ip-address
[_SourceAddress]
Defines the source IP address of the caller, for IP-to-Tel calls. The
source IP address appears in the SIP Contact header in the INVITE
message.
The default value is the asterisk (*) symbol (i.e., any IP address). The
source IP address can include the following wildcards:
"x" wildcard: represents single digits. For example, 10.8.8.xx
represents all IP addresses between 10.8.8.10 to 10.8.8.99.
"*" (asterisk) wildcard: represents any number between 0 and 255.
For example, 10.8.8.* represents all IP addresses between 10.8.8.0
and 10.8.8.255.
Note: This parameter is applicable only to the Calling Name
Manipulation Table for IP-to-Tel Calls table.
Web: Source Host Prefix
CLI: src-host-prefix
[_SrcHost]
Defines the URI host name prefix of the incoming SIP INVITE message
in the From header.
The default value is the asterisk (*) symbol (i.e., any source host prefix).
Notes:
This parameter is applicable only to the Calling Name Manipulation
Table for IP-to-Tel Calls table.
If the P-Asserted-Identity header is present in the incoming INVITE
message, then the value of this parameter is compared to the P-
Asserted-Identity URI host name (instead of the From header).
Web: Destination Host
Prefix
CLI: dst-host-prefix
[_DestHost]
Defines the Request-URI host name prefix of the incoming SIP INVITE
message.
The default value is the asterisk (*) symbol (i.e., any destination host
prefix).
Note: This parameter is applicable only to the Calling Name
Manipulation Table for IP-to-Tel Calls table.
Operation (Action)
Web: Stripped Digits From
Left
EMS: Number Of Stripped
Digits
CLI: remove-from-left
[_RemoveFromLeft]
Defines the number of characters to remove from the left of the calling
name. For example, if you enter 3 and the calling name is
"company:john", the new calling name is "pany:john".
Web: Stripped Digits From
Right
EMS: Number Of Stripped
Digits
Defines the number of characters to remove from the right of the calling
name. For example, if you enter 3 and the calling name is
"company:name", the new name is "company:n".
To Next Page
Loading...
