AudioCodes Mediant 500L MSBR

User's Manual 26. Manipulation
Version 6.8 393 Mediant 500L MSBR
Parameter Description
Web: Source Trunk Group ID
CLI: src-trunk-group-id
[_SrcTrunkGroupID]
Defines the Trunk Group from where the Tel call is received.
To denote any Trunk Group, leave this field empty. The value -1
indicates that this field is ignored in the rule.
Notes:
 This parameter is applicable only to the Redirect Number Tel > IP
table.
 This parameter is not applicable to IP-to-IP call routing.
Web/EMS: Source IP
Address
CLI: src-ip-address
[_SourceAddress]
Defines the IP address of the caller. The IP address appears in the
SIP Contact header of the incoming INVITE message.
The default value is the asterisk (*) symbol (i.e., any IP address). The
value can include the following wildcards:
 "x": represents single digits, for example, 10.8.8.xx denotes all
addresses between 10.8.8.10 and 10.8.8.99.
 "*": represents any number between 0 and 255, for example,
10.8.8.* denotes all addresses between 10.8.8.0 and 10.8.8.255.
Note: This parameter is applicable only to the Redirect Number IP-to-
Tel table.
Web: Source Host Prefix
CLI: src-host-prefix
[_SrcHost]
Defines the URI host name prefix of the caller. The host name
appears in the SIP From header of the incoming SIP INVITE
message.
The default value is the asterisk (*) symbol (i.e., any host name
prefix).
Notes:
 This parameter is applicable only to the Redirect Number IP-to-Tel
table.
 If the P-Asserted-Identity header is present in the incoming INVITE
message, then the value of this parameter is compared to the P-
Asserted-Identity URI host name (instead of to the From header).
Web: Destination Host Prefix
CLI: dst-host-prefix
[_DestHost]
Defines the Request-URI host name prefix, which appears in the
incoming SIP INVITE message.
The default value is the asterisk (*) symbol (i.e., any prefix).
Note: This parameter is applicable only to the Redirect Number IP-to-
Tel table.
Operation (Action)
Web: Stripped Digits From
Left
EMS: Remove From Left
CLI: remove-from-left
[_RemoveFromLeft]
Defines the number of digits to remove from the left of the redirect
number prefix. For example, if you enter 3 and the redirect number is
5551234, the new number is 1234.
Web: Stripped Digits From
Right
EMS: Remove From Right
CLI: remove-from-right
[_RemoveFromRight]
Defines the number of digits to remove from the right of the redirect
number prefix. For example, if you enter 3 and the redirect number is
5551234, the new number is 5551.
Web/EMS: Number of Digits
to Leave
CLI: num-of-digits-to-leave
[_LeaveFromRight]
Defines the number of digits that you want to retain from the right of
the redirect number.
Web/EMS: Prefix to Add
Defines the number or string that you want added to the front of the