User's Manual 394 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
[_Prefix2Add]
redirect number. For example, if you enter 9 and the redirect number
is 1234, the new number is 91234.
Web/EMS: Suffix to Add
CLI: suffix-to-add
[_Suffix2Add]
Defines the number or string that you want added to the end of the
redirect number. For example, if you enter 00 and the redirect number
is 1234, the new number is 123400.
Web: Presentation
EMS: Is Presentation
Restricted
CLI: is-presentation-
restricted
[_IsPresentationRestricted]
Enables caller ID.
Not Configured = Privacy is determined according to the Caller ID
table (see Configuring Caller Display Information on page 492).
[0] Allowed = Sends Caller ID information when a call is made
using these destination / source prefixes.
[1] Restricted = Restricts Caller ID information for these prefixes.
Note: If this parameter is set to Restricted and the 'AssertedIdMode'
parameter is set to Add P-Asserted-Identity, the From header in the
INVITE message includes the following:
From: 'anonymous' <sip:
anonymous@anonymous.invalid> and 'privacy: id'
Web: TON
EMS: Number Type
CLI: ton
[_NumberType]
Defines the Type of Number (TON).
The default is Not Configured [-1].
If NPI is set to Unknown, you can set TON to Unknown [0].
If NPI is set to Private, you can set TON to Unknown [0],
International [1], National [2], Network Specific [3] or Subscriber
[4].
If NPI is set to E.164 Public, you can set TON to Unknown [0],
International [1], National [2], Network Specific [3], Subscriber [4]
or Abbreviated [6].
For more information on available NPI/TON values, see Numbering
Plans and Type of Number on page 403.
Web: NPI
EMS: Number Plan
CLI: npi
[_NumberPlan]
Defines the Numbering Plan Indicator (NPI).
[-1] Not Configured = (Default) Value received from PSTN/IP is
used
[0] Unknown
[1] E.164 Public
[9] Private
For more information on available NPI/TON values, see Numbering
Plans and Type of Number on page 403.
To Next Page
Loading...
