AudioCodes Mediant 500L MSBR

User's Manual 46. Software Upgrade
Version 6.8 633 Mediant 500L MSBR
46.1.5.2.2 Configuring GW User Info Table in CLI
The GW User Info table can be configured in the CLI using the following commands:

To add and/or modify a user (example):
# configure voip
(config-voip)# sip-definition proxy-and-registration
(sip-def-proxy-and-reg)# user-info gw-user-info <index, e.g.,
1>
(gw-user-info-1)# username JohnDee
(gw-user-info-1)# <activate | exit>

To delete a specific user, use the no command:
(sip-def-proxy-and-reg)# no user-info gw-user-info <index,
e.g., 1>

To view all table entries:
(sip-def-proxy-and-reg)# user-info gw-user-info display
---- gw-user-info-0 ----
pbx-ext (405)
global-phone-num (405)
display-name (Ext405)
username (user405)
password (0aGzoKfh5uI=)
status (not-resgistered)

To view a specific entry (example):
(sip-def-proxy-and-reg)# user-info gw-user-info <index, e.g.,
0>
(gw-user-info-0)# display
pbx-ext (405)
global-phone-num (405)
display-name (Ext405)
username (user405)
password (0aGzoKfh5uI=)
status (not-resgistered)

To search a user by pbx-ext:
(sip-def-proxy-and-reg)# user-info find <pbx-ext e.g., 405>
405: Found at index 0 in GW user info table, not registered
46.1.5.2.3 Configuring GW User Info Table in Loadable Text File
The GW User Info table can be configured as a User Info file using a text-based file (*.txt).
This file can be created using any text-based program such as Notepad. You can load the
User Info file using any of the following methods:

Web interface - see ''Loading Auxiliary Files'' on page 615

ini file, using the UserInfoFileName parameter - see ''Auxiliary and Configuration File
Name Parameters'' on page
791

Automatic Update mechanism, using the UserInfoFileURL parameter - see Automatic
Update Mechanism
To add mapping rules to the User Info file, use the following syntax:
[ GW ]
FORMAT
PBXExtensionNum,GlobalPhoneNum,DisplayName,UserName,Password
Where:

[ GW ] indicates that this part of the file is the GW User Info table