AudioCodes Mediant 500L MSBR

User's Manual 62. Testing SIP Signaling Calls
Version 6.8 759 Mediant 500L MSBR
Parameter Description

For REGISTER messages, if option [1] is used, only Server-
type IP Groups can be used.
IP Group ID
CLI: ip-group-id
[Test_Call_IPGroupID]
Defines the IP Group ID to which the test call is sent or from
which it is received.
Notes:
 This parameter is applicable only if option [1] is configured for
the 'Route By' parameter.
 This IP Group is used for incoming and outgoing calls.
Destination Address
CLI: dst-address
[Test_Call_DestAddress]
Defines the destination host. This can be defined as an IP
address[:port] or DNS name[:port].
Note: This parameter is applicable only if the 'Route By'
parameter is set to [2] (Dest Address).
Destination Transport Type
CLI: dst-transport
[Test_Call_DestTransportType]
Defines the transport type for outgoing calls.
 [-1] = Not configured (default)
 [0] UDP
 [1] TCP
 [2] TLS
Note: This parameter is applicable only if the 'Route By'
parameter is set to [2] (Dest Address).
SRD
CLI: srd
[Test_Call_SRD]
Defines the SRD for the endpoint.
The default is SRD 0.
Note: This parameter is applicable only if the 'Route By'
parameter is set any option except [1] (IP Group).
Application Type
CLI: application-type
[Test_Call_ApplicationType]
Defines the application type for the endpoint. This, in effect,
associates the IP Group and SRD to a specific SIP interface. For
example, assume two SIP Interfaces are configured in the SIP
Interface table where one is set to "GW & IP2IP" and one to
"SBC" for the 'Application Type'. If this parameter is set ot "SBC",
the device uses the SIP Interface set to "SBC".
 [0] GW & IP2IP (default)
 [2] SBC
QoE Profile
CLI: qoe-profile
[Test_Call_QOEProfile]
Assigns a QoE Profile to the test call. To configure QoE Profiles,
see ''Configuring Quality of Experience Profiles'' on page 264.
Bandwidth Profile
CLI: bandwidth-profile
[Test_Call_BWProfile]
Assigns a Bandwidth Profile to the test call. To configure
Bandwidth Profiles, see ''Configuring Bandwidth Profiles'' on page
268.
Authentication Tab
Note: These parameters are applicable only if the Call Party parameter is set to Caller.
Auto Register
CLI: auto-register
[Test_Call_AutoRegister]
Enables automatic registration of the endpoint. The endpoint can
register to the device itself or to the 'Destination Address' or 'IP
Group ID' parameter settings (see above).
 [0] Disable (default)
 [1] Enable
Username
CLI: user-name
Defines the authentication username.
By default, no username is defined.