User's Manual 786 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
[AlarmHistoryTableMaxSize]
Defines the maximum number of rows in the Alarm History
table. This parameter can be controlled by the Config Global
Entry Limit MIB (located in the Notification Log MIB).
The valid range is 50 to 1000. The default is 500.
Note: For this parameter to take effect, a device reset is
required.
CLI: engine-id
[SNMPEngineIDString]
Defines the SNMP engine ID for SNMPv2/SNMPv3 agents.
This is used for authenticating a user attempting to access
the SNMP agent on the device.
The ID can be a string of up to 36 characters. The default is
00:00:00:00:00:00:00:00:00:00:00:00 (12 Hex octets
characters). The provided key must be set with 12 Hex
values delimited by a colon (":") in the format xx:xx:...:xx. For
example, 00:11:22:33:44:55:66:77:88:99:aa:bb
Notes:
For this parameter to take effect, a device reset is
required.
Before setting this parameter, all SNMPv3 users must be
deleted; otherwise, the parameter setting is ignored.
If the supplied key does not pass validation of the 12 Hex
values input or it is set with the default value, the engine
ID is generated according to RFC 3411.
Web: SNMP Trap Destination Parameters
EMS: Network > SNMP Managers Table
CLI: configure system/snmp trap destination
Note: Up to five SNMP trap managers can be defined.
SNMP Manager
[SNMPManagerIsUsed_x]
Determines the validity of the parameters (IP address and
port number) of the corresponding SNMP Manager used to
receive SNMP traps.
[0] (Check box cleared) = Disabled (default)
(Check box selected) = Enabled
Web: IP Address
EMS: Address
CLI: ip-address
[SNMPManagerTableIP_x]
Defines the IP address of the remote host used as an SNMP
Manager. The device sends SNMP traps to this IP address.
Enter the IP address in dotted-decimal notation, e.g.,
108.10.1.255.
Web: Trap Port
EMS: Port
CLI: port
[SNMPManagerTrapPort_x]
Defines the port number of the remote SNMP Manager. The
device sends SNMP traps to this port.
The valid SNMP trap port range is 100 to 4000. The default
port is 162.
Web: Trap Enable
CLI: send-trap
[SNMPManagerTrapSendingEnable
_x]
Enables the sending of traps to the corresponding SNMP
manager.
[0] Disable = Sending is disabled.
Enable = (Default) Sending is enabled.
Web: Trap User
CLI: trap-user
[SNMPManagerTrapUser_x]
Defines the SNMPv3 USM user or SNMPv2 user to
associate with the trap destination. This determines the trap
format, authentication level, and encryption level. By default,
it is associated with the SNMPv2 user (SNMP trap
community string).
The valid value is a string.
To Next Page
Loading...
