AudioCodes Mediant 500L MSBR

User's Manual 67. Configuration Parameters Reference
Version 6.8 809 Mediant 500L MSBR
Parameter Description
bundling occurs). The default is 1220.
Note: This parameter is applicable only if the GWDebugLevel
parameter is enabled.
Web: Syslog CPU Protection
CLI: configure
system/logging/syslog-cpu-
protection
[SyslogCpuProtection]
Enables the protection of the device's CPU resources during
debug reporting, ensuring voice traffic is unaffected. If CPU
resources drop (i.e., high CPU usage) to a critical level (threshold),
the device automatically lowers the debug level to free up CPU
resources that were required for the previous debug-level
functionality. When sufficient CPU resources become available
again, the device increases the debug level. The threshold is
configured by the 'Debug Level High Threshold' parameter (see
below).
 [0] Disable

[1]
Enable (default)
Web: Debug Level High
Threshold
CLI: debug-level-high-threshold
[DebugLevelHighThreshold]
Defines the threshold (in percentage) for automatically switching to
a different debug level, depending on CPU usage. The parameter
is applicable only if the 'Syslog CPU Protection' parameter is
enabled.
The valid value is 0 to 100. The default is 90.
The debug level is changed upon the following scenarios:
 CPU usage equals threshold: Debug level is reduced one level.
 CPU usage is at least 5% greater than threshold: Debug level
is reduced another level.
 CPU usage is 5 to 19% less than threshold: Debug level is
increased by one level.
 CPU usage is at least 20% less than threshold: Debug level is
increased by another level.
For example, assume that the threshold is set to 70% and the
Debug Level to Detailed (5). When CPU usage reaches 70%, the
debug level is reduced to Basic (1). When CPU usage increases
by 5% or more than the threshold (i.e., greater than 75%), the
debug level is disabled - No Debug (0). When the CPU usage
decreases to 5% less than the threshold (e.g., 65%), the debug
level is increased to Basic (1). When the CPU usage decreases to
20% less than the threshold (e.g., 50%), the debug level changes
to Detailed (5).
Note: The device does not increase the debug level to a level that
is higher than what you configured for the 'Debug Level'
parameter.
Web: Syslog Facility Number
EMS: SyslogFacility
[SyslogFacility]
Defines the Facility level (0 through 7) of the device’s Syslog
messages, according to RFC 3164. This allows you to identify
Syslog messages generated by the device. This is useful, for
example, if you collect the device’s and other equipments’ Syslog
messages, at one single server. The device’s Syslog messages
can easily be identified and distinguished from other Syslog
messages by its Facility level. Therefore, in addition to filtering
Syslog messages according to IP address, the messages can be
filtered according to Facility level.
 [16] = (Default) local use 0 (local0)
 [17] = local use 1 (local1)
 [18] = local use 2 (local2)
 [19] = local use 3 (local3)