AudioCodes Mediant 500L MSBR - Page 944

User's Manual 944 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
unknown/unrecognized IE. By default, the Status message is
sent.
Note: This value is applicable only to ISDN variants in which
sending of Status message is optional.
 [2] NO STATUS ON INV OP IE = Q.931 Status message isn't
sent if an optional IE with invalid content is received. By default,
the Status message is sent.
Note: This option is applicable only to ISDN variants in which
sending of Status message is optional.
 [4] ACCEPT UNKNOWN FAC IE = Accepts
unknown/unrecognized Facility IE. Otherwise, the Q.931
message that contains the unknown Facility IE is rejected
(default).
Note: This option is applicable only to ISDN variants where a
complete ASN1 decoding is performed on Facility IE.
 [128] SEND USER CONNECT ACK = The Connect ACK
message is sent in response to received Q.931 Connect;
otherwise, the Connect ACK is not sent.
Note: This option is applicable only to Euro ISDN User side
outgoing calls.
 [2048] ALWAYS EXPLICIT = Always set the Channel
Identification IE to explicit Interface ID, even if the B-channel is
on the same trunk as the D-channel.
Note: This value is applicable only to 4/5ESS, DMS and NI-2
variants.
 [32768] ACCEPT MU LAW =Mu-Law is also accepted in ETSI.
 [65536] EXPLICIT PRES SCREENING = The calling party
number (octet 3a) is always present even when presentation
and screening are at their default.
Note: This option is applicable only to ETSI, NI-2, and 5ESS.
 [131072] STATUS INCOMPATIBLE STATE = Clears the call on
receipt of Q.931 Status with incompatible state. Otherwise, no
action is taken (default).
 [262144] STATUS ERROR CAUSE = Clear call on receipt of
Status according to cause value.
 [524288] ACCEPT A LAW =A-Law is also accepted in 5ESS.
 [2097152] RESTART INDICATION = Upon receipt of a Restart
message, acEV_PSTN_RESTART_CONFIRM is generated.
 [4194304] FORCED RESTART = On data link (re)initialization,
send RESTART if there is no call.
 [67108864] NS ACCEPT ANY CAUSE = Accept any Q.850
Cause IE from ISDN.
Note: This option is applicable only to Euro ISDN.
 [134217728] NS_BRI_DL_ALWAYS_UP (0x08000000) = By
default, the BRI D-channel goes down if there are no active
calls. If this option is configured, the BRI D-
channel is always up
and synchronized.
 [536870912] = Alcatel coding for redirect number and display
name is accepted by the device.
Note: This option is applicable only to QSIG (and relevant for
specific Alcatel PBXs such as OXE).
 [1073741824] QSI ENCODE INTEGER = If this bit is set,
INTEGER ASN.1 type is used in operator coding (compliant to
new ECMA standards); otherwise, OBJECT IDENTIFIER ASN.1
type is used.