User's Manual 67. Configuration Parameters Reference
Version 6.8 945 Mediant 500L MSBR
Parameter Description
Note: This option is applicable only to QSIG.
[2147483648] 5ESS National Mode For Bch Maintenance =
Use the National mode of AT&T 5ESS for B-channel
maintenance.
Notes:
To configure the device to support several ISDNIBehavior
features, enter a summation of the individual feature values. For
example, to support both [512] and [2048] features, set the
parameter ISDNIBehavior is set to 2560 (i.e., 512 + 2048).
When configuring in the Web interface, to select the options
click the arrow button and then for each required option select 1
to enable.
For BRI terminal endpoint identifier (TEI) configuration, instead
of using the ISDNIBehavior parameter, use the following
parameters: BriTEIConfigP2P_x, BriTEIConfigP2MP_x,
BriTEIAssignTrigger_x, and BriTEIRemoveTrigger_x.
[ISDNIBehavior_x]
Same as the description for parameter ISDNIBehavior, but for a
specific trunk ID.
Web: General Call Control
Behavior
EMS: General CC Behavior
CLI: isdn-bits-cc-behavior
[ISDNGeneralCCBehavior]
Bit-field for determining several general CC behavior options. To
select the options, click the arrow button, and then for each
required option, select 1 to enable. The default is 0 (i.e., disable).
[2] = Data calls with interworking indication use 64 kbps B-
channels (physical only).
[8] REVERSE CHAN ALLOC ALGO = Channel ID allocation
algorithm.
[16] = The device clears down the call if it receives a NOTIFY
message specifying 'User-Suspended'. A NOTIFY (User-
Suspended) message is used by some networks (e.g., in Italy or
Denmark) to indicate that the remote user has cleared the call,
especially in the case of a long distance voice call.
[256] START WITH B CHAN OOS = B-channels start in the
Out-Of-Service state (OOS).
[512] CHAN ALLOC LOWEST = CC allocates B-channels
starting from the lowest available B-channel id.
[1024] CHAN ALLOC HIGHEST = CC allocates B-channels
starting from the highest available B-channel id.
[16384] CC_TRANSPARENT_UUI bit: The UUI-protocol
implementation of CC is disabled allowing the application to
freely send UUI elements in any primitive, regardless of the
UUI-protocol requirements (UUI Implicit Service 1). This allows
more flexible application control on the UUI. When this bit is not
set (default behavior), CC implements the UUI-protocol as
specified in the ETS 300-403 standards for Implicit Service 1.
[65536] GTD5 TBCT = CC implements the VERIZON-GTD-5
Switch variant of the TBCT Supplementary Service, as specified
in FSD 01-02-40AG Feature Specification Document from
Verizon. Otherwise, TBCT is implemented as specified in GR-
2865-CORE specification (default behavior).
Note: When using the ini file to configure the device to support
several ISDNGeneralCCBehavior features, add the individual
feature values. For example, to support both [16] and [32] features,
set ISDNGeneralCCBehavior = 48 (i.e., 16 + 32).
Determines several behaviour options (bit fields) that influence the
To Next Page
Loading...
