AudioCodes Mediant 500L MSBR

User's Manual 946 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
Behavior
CLI: isdn-bits-outgoing-calls-
behavior
[ISDNOutCallsBehavior]
behaviour of the ISDN Stack outgoing calls. To select options, click
the arrow button, and then for each required option, select 1 to
enable. The default is 0 (i.e., disable).
 [2] USER SENDING COMPLETE =The default behavior of the
device (when this bit is not set) is to automatically generate the
Sending-Complete IE in the Setup message. This behavior is
used when overlap dialing is not needed. When overlap dialing
is needed, set this bit and the behavior is changed to suit the
scenario, i.e., Sending-Complete IE is added when required in
the Setup message for Enblock mode or in the last Digit with
Overlap mode.
 [16] USE MU LAW = The device sends G.711-m-Law in
outgoing voice calls. When disabled, the device sends G.711-A-
Law in outgoing voice calls.
Note: This option is applicable only to the Korean variant.
 [128] DIAL WITH KEYPAD = The device uses the Keypad IE to
store the called number digits instead of the CALLED_NB IE.
Note: This option is applicable only to the Korean variant
(Korean network). This is useful for Korean switches that don't
accept the CALLED_NB IE.
 [256] STORE CHAN ID IN SETUP = The device forces the
sending of a Channel-Id IE in an outgoing Setup message even
if it's not required by the standard (i.e., optional) and no
Channel-Id has been specified in the establishment request.
This is useful for improving required compatibility with switches.
On BRI lines, the Channel-Id IE indicates ‘any channel’. On PRI
lines it indicates an unused channel ID, preferred only.
 [572] USE A LAW = The device sends G.711 A-Law in outgoing
voice calls. When disabled, the device sends the default G.711-
Law in outgoing voice calls.
Note: This option is applicable only to the E10 variant.
 [2048] = The device accepts any IA5 character in the called_nb
and calling_nb strings and sends any IA5 character in the
called_nb, and is not restricted to extended digits only (i.e., 0-
9,*,#).
 [16384] DLCI REVERSED OPTION = Behavior bit used in the
IUA interface groups to indicate that the reversed format of the
DLCI field must be used.
Note: When using the ini file to configure the device to support
several ISDNOutCallsBehavior features, add the individual feature
values. For example, to support both [2] and [16] features, set
ISDNOutCallsBehavior = 18 (i.e., 2 + 16).
[ISDNOutCallsBehavior_x]
Same as the description for parameter ISDNOutCallsBehavior, but
for a specific trunk ID.
Web: ISDN NS Behaviour 2
CLI: isdn-bits-ns-extension-
behavior
[ISDNNSBehaviour2]
Bit-field to determine several behavior options that influence the
behavior of the Q.931 protocol.
 [8] NS BEHAVIOUR2 ANY UUI = Any User to User Information
Element (UUIE) is accepted for any protocol discriminator. This
is useful for interoperability with non-standard switches.
 [16] NS BEHAVIOUR2 DISPLAY = The Display IE is accepted
even if it is not defined in the QSIG ISDN protocol standard.
This is applicable only when configuration is QSI.
 [64] NS BEHAVIOUR2 FAC REJECT = When this bit is set, the
device answers with a Facility IE message with the Reject