User's Manual 67. Configuration Parameters Reference
Version 6.8 957 Mediant 500L MSBR
Parameter Description
Web: IPMedia Detectors
EMS: DSP Detectors Enable
CLI: IPM-detectors-enable
[EnableDSPIPMDetectors]
Enables the device's DSP detectors.
[0] = Disable (default)
[1] = Enable
Notes:
For this parameter to take effect, a device reset is required.
The DSP Detectors feature is available only if the device is
installed with a Software License Key that includes this feature.
For installing a Software License Key, see ''Software License
Key'' on page 638.
When enabled (1), the number of available channels is reduced.
Web: Add IE in SETUP
EMS: IE To Be Added In Q.931
Setup
CLI: add-ie-in-setup
[AddIEinSetup]
Global parameter that defines an optional Information Element (IE)
data (in hex format) to add to ISDN Setup messages. You can also
configure this functionality per specific calls, using IP Profiles
(IpProfile_AddIEInSetup). For a detailed description of this
parameter and for configuring this functionality in the IP Profile
table, see ''Configuring IP Profiles'' on page 332.
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated with
the IP Profile.
Web: Trunk Groups to Send IE
EMS: List Of Trunk Groups To
Send IE
CLI: trkgrps-to-snd-ie
[SendIEonTG]
Defines Trunk Group IDs (up to 50 characters) from where the
optional ISDN IE (defined by the parameter AddIEinSetup) is sent.
For example: '1,2,4,10,12,6'.
Notes:
You can configure different IE data for Trunk Groups by defining
this parameter for different IP Profile IDs (using the parameter
IPProfile), and then assigning the required IP Profile ID in the
Inbound IP Routing table (PSTNPrefix).
When IP Profiles are used for configuring different IE data for
Trunk Groups, this parameter is ignored.
Web: Enable User-to-User IE
for Tel to IP
EMS: Enable UUI Tel 2 Ip
CLI: uui-ie-for-tel2ip
[EnableUUITel2IP]
Enables transfer of User-to-User (UU) IE from ISDN PRI to SIP.
[0] Disable (default)
[1] Enable
The device supports the following ISDN PRI-to-SIP interworking:
Setup to SIP INVITE, Connect to SIP 200 OK, User Information to
SIP INFO, Alerting to SIP 18x response, and Disconnect to SIP
BYE response messages.
Note: The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS PRI variants.
Web: Enable User-to-User IE
for IP to Tel
EMS: Enable UUI Ip 2 Tel
CLI: uui-ie-for-ip2tel
[EnableUUIIP2Tel]
Enables interworking of SIP user-to-user information (UUI) to User-
to-User IE in ISDN Q.931 messages.
[0] Disable = (Default) Received UUI is not sent in ISDN
message.
[1] Enable = The device interworks UUI from SIP to ISDN
messages. The device supports the following SIP-to-ISDN
interworking of UUI:
SIP INVITE to Q.931 Setup
SIP REFER to Q.931 Setup
SIP 200 OK to Q.931 Connect
SIP INFO to Q.931 User Information
SIP 18x to Q.931 Alerting
SIP BYE to Q.931 Disconnect
To Next Page
Loading...
