AudioCodes Mediant 500L MSBR - Page 958

User's Manual 958 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
Notes:
 The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS PRI variants.
 To interwork the UUIE header from SIP-to-ISDN messages with
the 4ESS ISDN v
ariant, the ISDNGeneralCCBehavior parameter
must be set to 16384.
[Enable911LocationIdIP2Tel]
Enables interworking of Emergency Location Identification from SIP
to PRI.
 [0] = Disabled (default)
 [1] = Enabled
When enabled, the From header received in the SIP INVITE is
translated into the following ISDN IE's:
 Emergency Call Control.
 Generic Information - to carry the Location Identification Number
information.
 Generic Information - to carry the Calling Geodetic Location
information.
Note: This capability is applicable only to the NI-2 ISDN variant.
CLI: early-answer-timeout
[EarlyAnswerTimeout]
Global parameter that defines the duration (in seconds) that the
device waits for an ISDN Connect message from the called party
(Tel side), started from when it sends a Setup message. You can
also configure this functionality per specific calls, using IP Profiles
(IpProfile_EarlyAnswerTimeout). For a detailed description of this
parameter and for configuring this functionality in the IP Profile
table, see ''Configuring IP Profiles'' on page 332.
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated with
the IP Profile.
Web/EMS: Trunk Transfer
Mode
CLI: trk-xfer-mode-type
[TrunkTransferMode]
Determines the trunk transfer method (for all trunks) when a SIP
REFER message is received. The transfer method depends on the
Trunk's PSTN protocol (configured by the parameter ProtocolType)
and is applicable only when one of these protocols are used:
PSTN Protocol Transfer Method (Described Below)
E1 Euro ISDN [1] ECT [2] or InBand [5]
E1 QSIG [21],
T1 QSIG [23]
Single Step Transfer [4], Path
Replacement Transfer [2], or InBand [5]
T1 NI2 ISDN [10],
T1 4ESS ISDN [11],
T1 5ESS 9 ISDN [12]
TBCT [2] or InBand [5]
T1 DMS-100 ISDN [14] RTL [2] or InBand [5]
T1 RAW CAS [3], T1
CAS [2], E1 CAS [8],
E1 RAW CAS [9]
[1] CAS NFA DMS-100 or [3] CAS
Normal transfer
T1 DMS-100 Meridian
ISDN [35]
RTL [2] or InBand [5]
The valid values of this parameter are described below:

[0]
= Not supported (default).