AudioCodes Mediant 500L MSBR

User's Manual 67. Configuration Parameters Reference
Version 6.8 979 Mediant 500L MSBR
Parameter Description
 During an existing call, if a call comes in (call waiting),
pressing the flash button places the active call on hold
and answers the waiting call; pressing flash again
toggles between these two calls.
 [1] Sequence 1 = Sequence of flash button with digit:

Flash + 1: holds a call or toggles between two existing
calls

Flash + 2: makes a call transfer.

Flash + 3: makes a three-way conference call (if the
Three-Way Conference feature is enabled, i.e., the
parameter Enable3WayConference is set to 1 and the
parameter 3WayConferenceMode is set to 2).
 [2] Sequence 2 = Sequence of flash button with digit:

Flash only: Places a call on hold.

Flash + 1:
1) When the device handles two calls (an active and a
held call) and this key sequence is dialed, it sends a SIP
BYE message to the active call and the previously held
call becomes the active call.
2) When there is an active call and an incoming waiting
call, if this key sequence is dialed, the device
disconnects the active call and the waiting call becomes
an active call.

Flash + 2: Places a call on hold and answers a call-
waiting call, or toggles between active and on-hold calls.

Flash + 3: Makes a three-way conference call. This is
applicable only if the Enable3WayConference parameter
is set to 1 and the 3WayConferenceMode parameter is
set to 2. Note that the settings of the ConferenceCode
parameter is ignored.

Flash + 4: Makes a call transfer.
Note: This parameter is applicable only to FXS interfaces.
Web: Flash Keys Sequence
Timeout
CLI: flash-key-seq-tmout
[FlashKeysSequenceTimeout]
Defines the Flash keys sequence timeout - the time (in msec)
that the device waits for digits after the user presses the flash
button (Flash Hook + Digit mode - when the parameter
FlashKeysSequenceStyle is set to 1 or 2).
The valid range is 100 to 5,000. The default is 2,000.
Keypad Feature - Call Forward Parameters
Web: Forward Unconditional
EMS: Call Forward Unconditional
CLI: fwd-unconditional
[KeyCFUnCond]
Defines the keypad sequence to activate the immediate call
forward option.
Web: Forward No Answer
EMS: Call Forward No Answer
CLI: fwd-no-answer
[KeyCFNoAnswer]
Defines the keypad sequence to activate the forward on no
answer option.
Web: Forward On Busy
EMS: Call Forward Busy
CLI: fwd-on-busy
[KeyCFBusy]
Defines the keypad sequence to activate the forward on busy
option.
Web: Forward On Busy or No
Answer
EMS: CF Busy Or No Answer
Defines the keypad sequence to activate the forward on 'busy
or no answer' option.