AudioCodes Mediant 500L MSBR

User's Manual 986 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
Trunk Group Settings
Web: Trunk Group Settings
EMS: SIP Routing > Hunt Group
CLI: configure voip > gw hunt-or-trunk-
group trunk-group-setting
[TrunkGroupSettings]
This table parameter configures the rules for channel
allocation per Trunk Group.
The format of the ini file table parameter is as follows:
[TrunkGroupSettings]
FORMAT TrunkGroupSettings_Index =
TrunkGroupSettings_TrunkGroupId,
TrunkGroupSettings_ChannelSelectMode,
TrunkGroupSettings_RegistrationMode,
TrunkGroupSettings_GatewayName,
TrunkGroupSettings_ContactUser,
TrunkGroupSettings_ServingIPGroup,
TrunkGroupSettings_MWIInterrogationType,
TrunkGroupSettings_TrunkGroupName;
[\TrunkGroupSettings]
For a description of this table, see ''Configuring Trunk Group
Settings'' on page 375.
Web: Channel Select Mode
EMS: Channel Selection Mode
CLI: ch-select-mode
[ChannelSelectMode]
Defines the method for allocating incoming IP-to-Tel calls to
a channel. This parameter applies to the following:
 All Trunk Groups configured without a channel select
mode in the Trunk Group Settings table (see ''
Configuring
Trunk Group Settings'' on page 375).
 All channels and trunks configured without a Trunk Group
ID.
for all Trunk Groups channels that are configured without a
Trunk Group ID,.
 [0] By Dest Phone Number
 [1] Cyclic Ascending (default)
 [2] Ascending
 [3] Cyclic Descending
 [4] Descending
 [5] Dest Number + Cyclic Ascending.
 [6] By Source Phone Number
 [7] Trunk Cyclic Ascending
 [8] Trunk & Channel Cyclic Ascending
 [9] Ring to Hunt Group
 [10] Select Trunk By Supplementary Service Table
 [11] Dest Number + Ascending
For a detailed description of the parameter's options, see
''Configuring Trunk Group Settings'' on page 375.
Web: Default Destination Number
CLI: dflt-dest-nb
[DefaultNumber]
Defines the default destination phone number, which is used
if the received message doesn't contain a called party
number and no phone number is configured in the Trunk
Group table (see Configuring the Trunk Group on page 373
).
This parameter is used as a starting number for the list of
channels comprising all the device's Trunk Groups.
The default is 1000.