AudioCodes Mediant 500L MSBR

User's Manual 998 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
Indicator
CLI: redir-nb-si-2tel
[SetIp2TelRedirectScreeni
ngInd]

[0] User Provided
 [1] User Passed
 [2] User Failed
 [3] Network Provided
Note: This parameter is applicable only to digital PSTN interfaces
(ISDN).
Web: Set IP-to-TEL
Redirect Reason
CLI: ip2tel-redir-reason
[SetIp2TelRedirectReason]
Defines the redirect reason for IP-to-Tel calls. If redirect (diversion)
information is received from the IP, the redirect reason is set to the
value of this parameter before the device sends it on to the Tel.
 [-1] Not Configured (default)
 [0] Unkown
 [1] Busy
 [2] No Reply
 [3] Network Busy
 [4] Deflection
 [9] DTE out of Order
 [10] Forwarding DTE
 [13] Transfer
 [14] PickUp
 [15] Systematic/Unconditional
Note: This parameter is applicable only to digital PSTN interfaces
(ISDN).
Web: Set TEL-to-IP
Redirect Reason
CLI: tel2ip-redir-reason
[SetTel2IpRedirectReason]
Defines the redirect reason for Tel-to-IP calls. If redirect (diversion)
information is received from the Tel, the redirect reason is set to the
value of this parameter before the device sends it on to the IP.
 [-1] Not Configured (default)
 [0] Unkown
 [1] Busy
 [2] No Reply
 [3] Network Busy
 [4] Deflection
 [9] DTE out of Order
 [10] Forwarding DTE
 [13] Transfer
 [14] PickUp
 [15] Systematic/Unconditional
Note: This parameter is applicable only to digital PSTN interfaces
(ISDN).
Web: Send Screening
Indicator to IP
EMS: Screening Indicator
To IP
[ScreeningInd2IP]
Overrides the calling party's number (CPN) screening indication in the
received ISDN SETUP message for Tel-to-IP calls.
 [-1] Not Configured = (Default) Not configured (interworking from
ISDN to IP) or set to 0 for CAS.
 [0] User Provided = CPN set by user, but not screened (verified).
 [1] User Passed = CPN set by user, verified and passed.
 [2] User Failed = CPN set by user, and verification failed.
 [3] Network Provided = CPN set by network.
Note: This parameter is applicable only if the Remote Party ID (RPID)
header is enabled.