7. Advanced
W2 White Projector 2
Rc Red Common Color Gamut
Gc Green Common Color Gamut
Bc Blue Common Color Gamut
Wc White Common Color Gamut
The following parameters can be adjusted within DynaColor™:
• the x, y coordinates and L (Light Output) of the 6 Common Color Gamut perimeter points.
• the x, y coordinates and L (Light Output) of the White point of the Common Color Gamut.
The Dynacolor™ Interface
Field / item
Description
Measured values
The coordinates in the CIE Chromaticity diagram and luminance of the native
primary colors of the projector as they have been measured in ideal conditions in
the factory. Only Barco engineers may change these values.
X and Y coordinates Coordinates in the CIE Chromaticity diagram
Red, Green, Blue, White Native primary colors and native white of the projector
L value Luminance (relative value)
White L White luminance = Red + Blue + Green luminance (relative value)
Desired values Description
Desired values The coordinates in the CIE Chromaticity diagram and luminance of the desired
primary and secondary colors of the projector. Only Barco engineers may
change these values to force a common color triangle; Barco trained and
qualified engineers may also change the X and Y coordinates of the white
point to fine tune the colors.
X and Y coordinates
Coordinates in the CIE Chromaticity diagram
Red, Green, Blue, White Desired primary colors and desired white of the projector
Cyan, Yellow, Magenta Desired secondary colors of the projector
Lvalue
Luminance (relative value)
Lmax value
Maximum available luminance (relative value)
Button Description
Default desired Uses the Measured parameters to calculate and fill out the Desired values.
Factory Preset
Overwrites the Measured parameters by the factory measured values.
Calibration Starts the native primary color and native white color calibration procedure. Only
Barco engineers may perform a calibration. A professional spectrometer and
ideal measurement conditions are required to achieve a good calibration. Improper
calibration seriously affects the performance of the projector. See the SIM 7 service
manual for the detailed calibration procedure.
R59770198 BARCO SIM 7D 13/02/2013 123
To Next Page
Loading...
