4. Installation
Image 4-37
1 Function keys user programmable keys with functions for direct access.
2 MENU Menu key, to enter or exit the Tool bar menu.
3 Address key (recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9.
4
LOGO key
not implemented
5
PAUSE to stop projection for a short time, press ’PAUSE’. The image disappears but full power is
retained for immediate restarting.
6
STBY standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to go
to standby, press the standby key for 2 seconds.
7MUTE
to interrupt the sound reproduction (audio = optional.
8
AUTOIMAGE Auto image, to center the image on the active LCD surface.
9 Digit buttons direct input selection.
9b
SOURCE button the Source Selection menu is opened
10 Lens control
use these buttons to obtain the desired ZOOM, SHIFT, FOCUS.
11
VOL use this button to obtain the desired sound level (audio = optional)
12 Picture controls use these buttons to obtain the desired picture analog level.
13
DIGI ZOOM
not implemented
14 FREEZ
press to freeze the projected image.
15 PIP not implemented
R59770198 BARCO SIM 7D 13/02/2013 33
To Next Page
Loading...
