Field Description
• @H /- (default value): Your device is oper-
ated at 2.4 GHz inside or outside buildings.
• @H : Your device runs in 5 GHz inside buildings.
• @H -: Your device runs in 5 GHz outside build-
ings.
• @H /-: Your device is run with 5 GHz inside or
outside buildings.
Usage Area Only for Operation Mode = 3%% 61 and Operation
Band = @H or @H
Possible values:
• - (default value)
•
• -
Channel The number of channels you can select depends on the country
setting. Please consult the data sheet for your device.
Access Point Mode / Bridge Mode:
Configuring the network name (SSID) in Access Point mode
means that wireless networks can be logically separated from
each other, but they can still physically interfere with each other
if they are operating on the same or closely adjacent wireless
channels. So if you are operating two or more radio networks
close to each other, it is advisable to allocate the networks to
different channels. Each of these should be spaced at least four
channels apart, as a network also partially occupies the adja-
cent channels.
In the case of manual channel selection, please make sure first
that the clients actually support these channels.
Possible values:
• For Operation Band = @H /-
Possible values are to & and 3 (default value).
3 is not possible in bridge mode.
• For Operation Band = @H
bintec elmeg GmbH
8 Wireless LAN
bintec RS Series 155
To Next Page
Loading...
