Field Description
Protocol Select a protocol.
The 3( option (default value) matches any protocol.
Type Only for Protocol = 6'
Select the type.
Possible values: 3(, % +1(, 5 %
"1, % ;%, A%, %, * ?%,
*+, *+ +1(.
See RFC 792.
The default value is 3(.
Connection State With Protocol = *6, you can define a filter that takes the
status of the TCP connections into account.
Possible values:
• "1: All TCP packets that would not open any new
TCP connection on routing over the gateway match the filter.
• 3( (default value): All TCP packets match the filter.
Destination IPv4 Ad-
dress/Netmask
Enter the destination IPv4 address of the data packets and the
corresponding netmask.
Possible values:
• 3( (default value): The destination IP address/netmask are
not specified.
• @: Enter the destination IP address of the host.
• )79: Enter the destination network address and the cor-
responding netmask.
Destination IPv6 Ad-
dress/Length
Enter the destination IPv6 address of the data packets and the
prefix length.
Possible values:
• 3( (default value): The destination IP address/length are
not specified.
• @: Enter the destination IP address of the host.
• )79: Enter the destination network address and the pre-
bintec elmeg GmbH
10 Networking
bintec RS Series 261
To Next Page
Loading...
