Field Description
The function is enabled with "1.
The function is disabled by default.
End-to-End Send Inter-
val
Only if Loopback End-to-End is enabled.
Enter the time in seconds after which a loopback cell is to be
sent.
Possible values are to .
The default value is 5.
End-to-End Pending
Requests
Only if Loopback End-to-End is enabled.
Enter the number of directly consecutive loopback cells that
may fail to materialise before the connection is regarded as in-
terrupted ("down"). Possible values are to .
The default value is .
Loopback Segment Select whether you want to activate the loopback test for the
segment connection (segment = connection of the local end-
point to the next connection point) of the VCC or VPC.
The function is enabled with "1.
The function is disabled by default.
Segment Send Interval Only if Loopback Segment is enabled.
Enter the time in seconds after which a loopback cell is sent.
Possible values are to .
The default value is .
Segment Pending Re-
quests
Only if Loopback Segment is enabled.
Enter the number of directly consecutive loopback cells that
may fail to materialise before the connection is regarded as in-
terrupted ("down").
Possible values are to .
The default value is .
bintec elmeg GmbH
13 WAN
bintec RS Series 347
To Next Page
Loading...
