Bosch Rexroth Tightening System 350 - Page 154

154/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
TorqCtrL Torque control too low: Tightening torque too low
Output signal used for:
• Tightening channel (TorqCtrL)
• Communication unit in single-channel operation (CH x.y TorqCtrL)
Results description after a completed tightening sequence. The tightening torque is below the defined
limit.
TorqH Torque too high: Torque too high
Output signal used for:
• Tightening channel (TorqH)
• Communication unit in single-channel operation (CH x.y TorqH)
Results description after a completed tightening sequence. The torque is above the defined tolerance
window.
TorqL Torque too low: Torque too low
Output signal used for:
• Tightening channel (TorqL)
• Communication unit in single-channel operation (CH x.y TorqL)
Results description after a completed tightening sequence. The torque is below the defined tolerance
window.
TorqMaxH Torque max too high: Maximum torque too high
Output signal used for:
• Tightening channel (TorqMaxH)
• Communication unit in single-channel operation (CH x.y TorqMaxH)
Results description after a completed tightening sequence. The maximum torque is above the defined
tolerance window.
TorqMinL Torque min too low: Minimum torque too low
Output signal used for:
• Tightening channel (TorqMinL)
• Communication unit in single-channel operation (CH x.y TorqMinL)
Results description after a completed tightening sequence. The minimum torque is below the defined
tolerance window.
TorqRelH Torque relative too high: Relative torque too high
Output signal used for:
• Tightening channel (TorqRelH)
• Communication unit in single-channel operation (CH x.y TorqRelH)
Results description after a completed tightening sequence. The relative torque is above the defined
tolerance window.
TorqRelL Torque relative too low: Relative torque too low
Output signal used for:
• Tightening channel (TorqRelL)
• Communication unit in single-channel operation (CH x.y TorqRelL)
Results description after a completed tightening sequence. The relative torque is below the defined
tolerance window.