466/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
ID code data fields
6.10.2.3 Activation of Rexroth IPM Protocol
The Rexroth IPM Protocol is activated in the BS350 via System Tightening cell data IPM
Protocol with the following options:
6.10.3 Storing the configuration for Rexroth IPM Protocol
By using the File Save tightening cell menu item and activating the Rexroth IPM option, the files with
the configuration settings for Rexroth IPM Protocol (activation, XML, INI, FTP), protocol files as well as
status files can be saved. FTP settings are also saved if this is not explicitly selected in the window of the
BS350 operating system (see figure 6–9 on page 220). If an error with regard to Rexroth IPM Protocol
occurs while saving the tightening cell data, it is dealt with as follows:
• Unable to save files for Rexroth IPM Protocol
At the end of the saving process, the following entry is shown in the dialog window with the error
messages: Unable to save IPM configuration file: <File name>
In this connection, <File name> is replaced by the name of the file that could not be saved.
• Rexroth IPM Protocol is not supported on the tightening system, the corresponding files are,
however, to be saved (activation box checked)
The files are not saved. Moreover, the following entry is shown in the dialog box with the error messages
at the end of the saving process: Unable to save IPM configuration.
Table 6–145: ID code source
Name Key IPM data field Comments
IDCode Mask I/F #Ident no. Parts serial number (masked ID code)
AFOSer V Tightening case (V5)
Process no. (<=V4)
WTID B #Component carrier ID
TypID T Type
IDPlus Z #Additional ID
AFOPri S (#AFO) As of version V2.500: Application/channel ID: AFO, extracted from
the ID code (may be different for application and channel)
AFOSec K (#AFO) As of version V2.500: Only channel ID: AFO extension, the
characters are extended to AFO
Table 6–146: Settings for Rexroth IPM Protocol activation in the BS350
Element Description
Activated The data protocol is active if this option is selected.
Version Data protocol display: Rexroth IPM 1.0
(in the following, referred to as Rexroth IPM Protocol)
Open... Loading of stored data from a file.
Click this button to open an IPM configuration file (*.dcg file).
The *.dcg files can only be opened with the dialog window under which they have
been saved.
Save as ... Saving of data to a data carrier.
Print ... Output of settings via a printer or display as preview.
Default values Loading default settings
OK Transmission of the activation of the Rexroth IPM 1.0 data protocol to the controller.
The option is only released for logged in users.
Cancel Closes the dialog window without accepting the changes
To Next Page
Loading...
