3 608 878 300 Tightening Technology | Bosch Rexroth AG 467/641
System 350 | 3 608 878 300/2019-03
6.10.4 Status of Rexroth IPM Protocol
In online mode, the current configuration as well as the current status of Rexroth IPM Protocol can be
displayed:
• As of version V2.500 of the Rexroth Tightening System 350: System test Diagnosis IPM
This information (see table 6–147) is stored in an XML-file that can be saved and opened in XML-format
and printed in the BS350-specific report format.
If there is no status file for Rexroth IPM Protocol on the tightening controller, the fields in the status display
window of the BS350 remain empty. Apart from that, the following message is output: On the controller,
no status file available.
Table 6–147: Status information Rexroth IPM Protocol
Element Description
Initialization Status after initialization
Status "OK" means that the system has been correctly initialized.
Operating status Current status of Rexroth IPM Protocol
From Time at the moment of the status inquiry
IPM connection Status of the IPM communication, including
– Time of the last communication ("Last communication")
– Number of errors ("Errors")
– Number of packages ("Packages")
Host connection Status of the TCP connection (CS/KE) for the graph transmission, including
– Time of the last communication ("Last communication")
– Number of errors ("Errors")
– Number of packages ("Packages")
Events Display of the last events (error protocol)
Last IPM telegrams Display of the last IPM telegram
The display of the status values of Rexroth IPM Protocol is not continuously updated. To display the
current status, select the following as of version V2.500 of the Rexroth Tightening System 350: System
test Status IPM
To Next Page
Loading...
